Westermo TDW-33 User Manual
Page 21
6618-3202
21
\Kn – Break Control
Supported by:
TDW-33
TD-36
TD-36 485
TR-36
TR-36B
Description:
This command controls the response of the modem to a break signal received from the
terminal equipment, from the remote modem or through the \B command. The modem
can respond in three different ways depending on the state of the modem. The value is
written to S40 bit 3,4 and 5.
Syntax:
AT\K<n>
Parameters:
<n>
Mode 1
Modem is in on line data mode and a break is received from the DTE.
<n>
0:
Enter on-line command modem, no break sent to the remote modem.
1:
Clear data buffers and send break to remote modem.
2:
Same as 0.
3:
Send break to remote modem immediately.
4:
Same as 0.
5:
Send break to remote modem in sequence with transmitted data (Default).
Mode 2
Modem is in on line command mode and a \B is received in order send as a break to the
remote modem.
<n>
0:
Clear data buffers, send break to the remote modem.
1:
Same as 0.
2:
Send break to remote modem immediately.
3:
Same as 2.
4:
Send break to remote modem in sequence with transmitted data.
5:
Same as 4.