Westermo TDW-33 - Manual (Page 36)

6618-3202 36
Wn – Connect message control
Supported by: TDW-33 TD-36 TD-36 485 TR-36 TR-36B
Description:
This command controls the format of CONNECT message.
This command can be overide by ATS95 and AT\V commands.
Syntax:
ATW<n>
Parameters:
<n>
0: Upon connection, the modem reports only the DTE speed.
1: Upon connection, the modem reports the line speed, the error correction protocol,
and the DTE speed respectively.
2: Upon connection, the modem reports the DCE speed
Command example Possible responses Note
ATW OK <n> = 0,1,2
ERROR Otherwise
S register: The value is written to S31 bits 2 and 3.
&Wn – Store system setting
Supported by: TDW-33 TD-36 TD-36 485 TR-36 TR-36B
Description:
This command saves the current (active) configuration (profile), including S-Registers,
in one of the two user profiles as denoted by the parameter value.
Syntax:
AT&W<n>
Parameters:
<n>
0: Store the current configuration as profile 0
1: Store the current configuration as profile 1
Command example Possible responses Note
AT&W<n> OK Writes configuration
<n> to EEPROM
S register: None