Westermo TDW-33 - Manual (Page 59)

6618-3202 59
Xn – Extended Result Codes
Supported by: TDW-33 TD-36 TD-36 485 TR-36 TR-36B
Description:
This commands selects which subset of the result messages will be used by the modem
to inform the DTE of the results of commands.
Syntax:
ATX<n>
Parameters:
<n>
0: Enables result codes 0 through 4, the modem ignores dial tone and BUSY signals, if
allowed by the local PTT (blind dialling)
1: Enables all result codes except 6 and 7, the modem ignores dial tone and BUSY
signals, if allowed by the local PTT (blind dialling).
2: Enables all result codes except 7, the modem ignores busy signals, if allowed by the
local PTT.
3: Enables all result codes except 6, the modem ignores dial tone if allowed by the
local PTT.
4: Enables all result codes (default).
Command example Possible responses Note
ATX<n> OK
ERROR Otherwise
S register: The value is written to S22 bits 4,5 and 6.
&Yn – Designate a Default Reset Profile
Supported by: TDW-33 TD-36 TD-36 485 TR-36 TR-36B
Description:
This command selects which user profile will be used after a hard reset.
Syntax:
AT&Y<n>
Parameters:
<n>
0: The modem will use profile 0
1: The modem will use profile 1
Command example Possible responses Note
AT&Y<n> OK
ERROR Otherwise
S register: None.