ACTi Outdoor Dome on Straight Wall with Accessory Sets of PMAX-0314 - Manual (Page 20)

www.acti.com
Installation Guide
20
Step 1: Install the Wall Mount
1. Attach the drill template (included in the Heavy Duty Wall Mount package) to the wall and drill
the screw holes.
3. The use of the back plate is not necessary if installing the Wall Mount on a flat even surface.
However, in case the surface is rough or uneven, it is recommended to use the back plate to
ensure the Wall Mount is sealed from the inside.
Align the back plate to the Wall Mount and install the Wall Mount to the wall using four (4)
screws (purchased separately).
NOTE: Make sure to purchase screws applicable to the wall material where the wall mount is
to be installed.
2. Route the cable(s) to go along the wall.