ACTi Outdoor Dome on Straight Wall with Accessory Sets of PMAX-0314 - Manual (Page 43)

www.acti.com
Installation Guide
43
Sample installation at this point is shown below:
Step 6: Prepare the Camera for Installation
NOTE: To avoid scratches or leaving fingerprints on the dome cover, it is recommended to retain
the plastic covering the dome cover until the camera is completely installed. However, the plastic
has been removed on some of the pictures in this documentation to show clarity of the
procedures being described.
1. Remove the metal cap covering the bottom hole of the camera, and attach the cap to the side
hole to close it.
NOTE: Make sure the cap is secured tightly by using tools (like coin) to tighten the cap.
2. With the bundled hex screwdriver, loosen the three (3) screws securing the dome cover.