Emerson Process Management OXYMITTER 4000 IM-106-340 - Manual (Page 35)

Instruction Manual
IM-106-340, Rev. 4.0
May 2006
1-17
Oxymitter 4000
Signals
Analog Output/HART 4-20 mA isolated from power supply, 950 ohms
maximum load
Logic I/O Two-terminal logic contact configurable as either an
alarm output or as a bi-directional calibration
handshake signal to IMPS 4000 or SPS 4001B,
self-powered (+5 V) in series with 340 ohms
Conduit ports — 3/4 in.-14 NPT (for analog output and
logic I/O signal lines)
Power Requirements:
Probe Heater 175 W nominal
Electronics 10 W nominal
Maximum 500 W
Oxymitter Specifications