H3C Technologies H3C SecPath F1000-E - Manual (Page 128)

118
NOTE:
•
For installation and configuration about the security policy server, see CAMS EAD Security Policy
Component User Manual or IMC EAD Security Policy Help.
• The ACL for resources in the quarantined area and that for restricted resources correspond to isolation
ACL and security ACL on the security policy server respectively.
• You can modify the authorized ACLs on the access device. However, your changes take effect only for
portal users logging on after the modification.
Specifying a portal server for Layer 3 portal
authentication
Use this task to specify portal server parameters for Layer 3 portal authentication, including the portal
server IP address, shared encryption key, server port, and the URL address for Web authentication.
To specify a remote portal server for Layer 3 portal authentication:
Step Command Remarks
1. Enter system view. system-view N/A
2. Specify a portal server and
configure related parameters.
portal server server-name ip
ip-address [ key key-string | port
port-id | url url-string ] *
By default, no portal server is
specified.
NOTE:
•
You can specify four portal servers on the firewall at most.
• The specified parameters of a portal server can be modified or deleted only if the portal server is not
referenced on any interface.
Enabling Layer 3 portal authentication
Before enabling Layer 3 portal authentication on an interface, make sure that:
• An IP address is configured for the interface.
• The interface is not added to any port aggregation group.
• The portal server to be referenced on the interface exists.
Configuration guidelines
• You cannot enable portal authentication on a Layer 3 interface added to an aggregation group,
nor can you add a portal-enabled Layer 3 interface to an aggregation group.
• The destination port number that the firewall uses for sending unsolicited packets to the portal server
must be the same as that which the remote portal server actually uses.
• The portal server and its parameters can be deleted or modified only when the portal server is not
referenced by any interface.
• Cross-subnet authentication mode (portal server server-name method layer3) does not require
Layer 3 forwarding devices between the access device and the authentication clients. However, if