H3C Technologies H3C SecPath F1000-E - Manual (Page 139)

129
• Enter the start IP address and end IP address of the IP group. Make sure that the IP address of the
user host (2.2.2.2) is in the IP group.
• Select a service group. By default, the group Ungrouped is used.
• Select the IP group type Normal.
Figure 114 Adding an IP address group
# Add a portal device.
Select Portal Service Management > Device from the navigation tree to enter the portal device
configuration page. Click Add to enter the page shown in
Figure 115 .
• Enter the device name NAS.
• Enter the IP address of the SecPath's interface connected to the user.
• Enter the key, which must be the same as that configured on the SecPath.
• Set whether to enable IP address reallocation. Direct portal authentication is used in this example,
and therefore select No from the Reallocate IP list.
• Set whether to support the portal server heartbeat and user heartbeat functions. In this example,
select No for both Support Server Heartbeat and Support User Heartbeat.
Figure 115 Adding a portal device
# Associate the portal device with the IP address group.
As shown in
Figure 116 , click the icon in the Port Group Information Management column of device NAS
to enter the port group configuration page.