H3C Technologies H3C SecPath F1000-E - Manual (Page 154)

144
Log in to IMC and select the Service tab. Then, select Portal Service Management > Server from the
navigation tree to enter the portal server configuration page, as shown in Figure 124 .
• Configure the portal server heartbeat interval and user heartbeat interval.
• Use the default value for other parameters.
Figure 124 Portal server configuration
# Configure an IP address group.
Select Portal Service Management > IP Group from the navigation tree to enter the portal IP address
group configuration page. Click Add to enter the page shown in
Figure 125 .
• Enter the IP group name.
• Enter the start IP address and end IP address of the IP address group. Make sure that the IP address
of the user host is within this IP address group.
• Select a service group. By default, the group Ungrouped is used.
• Select the IP group type Normal.
Figure 125 Adding an IP address group
# Add a portal device.
Select Portal Service Management > Device from the navigation tree to enter the portal device
configuration page. Click Add to enter the page shown in Figure 126 .
• Enter the device name NAS.
• Enter the IP address of the SecPath's interface connected to the host.
• Enter the key, which must be the same as that configured on the SecPath.