H3C Technologies H3C SecPath F1000-E - Manual (Page 170)

160
No. Attribute Description
7 Framed-Protocol Encapsulation protocol for framed access.
8 Framed-IP-Address IP address assigned to the user.
11 Filter-ID Name of the filter list.
12 Framed-MTU Maximum transmission unit (MTU) for the data link between the user and NAS.
14 Login-IP-Host IP address of the NAS interface that the user accesses.
15 Login-Service Type of the service that the user uses for login.
18 Reply-Message
Text to be displayed to the user, which can be used by the server to indicate, for
example, the reason of the authentication failure.
26 Vendor-Specific
Vendor specific attribute. A packet can contain one or more such proprietary
attributes, each of which can contain one or more sub-attributes.
27 Session-Timeout
Maximum duration of service to be provided to the user before termination of the
session.
28 Idle-Timeout Maximum idle time permitted for the user before termination of the session.
31 Calling-Station-Id Identification of the user that the NAS sends to the server.
32 NAS-Identifier Identification that the NAS uses for indicating itself.
40 Acct-Status-Type
Type of the Accounting-Request packet. Possible values are as follows:
• 1—Start.
• 2—Stop.
• 3—Interim-Update.
• 4—Reset-Charge.
• 7—Accounting-On. (Defined in 3GPP, the 3rd Generation Partnership
Project.)
• 8—Accounting-Off. (Defined in 3GPP.)
• 9 to 14—Reserved for tunnel accounting.
• 15—Reserved for failed.
45 Acct-Authentic
Authentication method used by the user. Possible values are as follows:
• 1—RADIUS
• 2—Local
• 3—Remote
60 CHAP-Challenge
CHAP challenge generated by the NAS for MD5 calculation during CHAP
authentication.
61 NAS-Port-Type
Type of the physical port of the NAS that is authenticating the user. Possible
values are as follows:
• 15—Ethernet
• 16—Any type of ADSL
• 17—Cable (with cable for cable TV)
• 201—VLAN
• 202—ATM
If the port is an ATM or Ethernet one and VLANs are implemented on it, the value
of this attribute is 201.
79 EAP-Message
Used for encapsulating EAP packets to allow the NAS to authenticate dial-in
users via EAP without having to understand the EAP protocol.