H3C Technologies H3C SecPath F1000-E - Manual (Page 229)

219
Figure 160 Adding an access device
2. Add a user for device management:
a. Click the User tab, and then select Access User View > Device Mgmt User from the navigation
tree.
b. Click Add to configure a device management user as follows:
Add a user hello@bbb and set the password.
Select Telnet as the service type.
Set the EXEC privilege level to 3. This value identifies the privilege level of the Telnet user after
login, which is 0 by default.
Specify IP addresses 10.1.1.0 to 10.1.1.255 as the range of hosts to be managed. The IP
address range of the hosts to be managed must contain the IP address of the access device
added in the previous step.
c. Click OK.