Grass Valley Performer SD - Manual (Page 75)

2-43
Installation Reference
Switcher Polling Address
Performer will accept a polling address from 0 to 255. A
polling address is necessary if more than one switcher is being
controlled by a single controller. The full address range is not
available to all protocols. Refer to the list below to see which
addresses your protocol allows.
Performer ASCII Full Range
TEN-XL ASCII 00-99 (2 BCD numbers. See
illustration.)
TEN-XL SMPTE 40-255 (28H-FFH)
GVG Model 100 or 110 Full Range
GVG Model 200 0-23
GVG Model 300 0-7
SMPTE 3245-E 40-255 (28H-FFH)
NOTE: For addressing, refer to the instructions for the control
panel you are using (page 2-54 f or Performer remote panel, or
page 2-75 for TEN –20, 20–TEN remote panels)