Sending data to a printer – HEIDENHAIN ND 1400 User Manual

Page 113

Advertising
background image

99

9

Communication

Sending data to a printer

The QC-330 supports certain USB printers. The printer must be approved for use by Metronics. The cur-

rent printer is shown in the Print setup screen discussed in

Chapter 10: Setup.

1 Verify that the QC-330 and printer power are off. Con-

nect the USB printer to the USB Type A port on the side of

the enclosure.

2 Make sure the USB cable plug is fully inserted.

Printer format strings

The formatting strings listed below include one or more

ASCII codes listed at the end of this chapter. This format-

ting is configured in the Print setup screen discussed in

Chapter 10: Setup.

• Pre Line: ASCII control character (or string) for printer control before printing a line.

• Post Line: ASCII control character (or string) for printer control after printing a line.

• Pre Form: ASCII control character (or string) for printer control before printing a form.

• Post Form: ASCII control character (or string) for printer control after printing a form.

Report formats

Reports of feature measurement data

can be printed with the formats dis-

cussed in the Print setup screen por-

tion of Chapter 10: Setup. These can

include:

• Number of lines per page

• Form

• Pre/Post line formats

• Pre/Post formats

• Axis labels

• Units of measure

Sending Data to a Computer and Printer

USB printer

port

Advertising