HEIDENHAIN ND 1400 - Manual (Page 122)

108 QC-300 Series User’s Guide
Minimum setup
In most cases, the QC-330 will be provided by a Metronics
distributor or an OEM and will be configured and ready to use.
Setup by the end-user will be unnecessary. However, if some
setup is required, a minimum sequence of steps should be per-
formed in the order shown by this diagram. Each block describes
a setup task and refers to pages where detailed instructions are
presented.
A variety of optional setup steps can be performed after the mini-
mum setup to specify display, reporting and other parameters.
These optional and all other setup parameters and screens are
described in detail in the remainder of this chapter.
Familiarize yourself with the methods of ac-
cessing and using the Setup menu described
on earlier pages before performing these mini-
mum or additional optional setup steps.
Page 141
Page 123
Page 127
Page 112
Page 118
Page 118
Page 117
Page 109