8 optional program-run interruption, Application – HEIDENHAIN TNC 640 (34059x-02) ISO programming User Manual

Page 532

Advertising
background image

Test run and program run

17.8

Optional program-run interruption

17

532

TNC 640 | User's Manual for DIN/ISO Programming | 5/2013

17.8

Optional program-run interruption

Application

The TNC optionally interrupts program run at blocks containing M1.

If you use M1 in the Program Run mode, the TNC does not switch

off the spindle or coolant.

Do not interrupt program run or test run at blocks

containing M1: Set soft key to OFF
Interrupt program run or test run at blocks

containing M1: Set soft key to ON

Advertising
See also other documents in the category HEIDENHAIN Equipment: