HEIDENHAIN TNC 640 (34059x-02) ISO programming - Manual (Page 595)

Functions of the TNC 640 and the iTNC 530 compared 19.5
19
TNC 640 | User's Manual for DIN/ISO Programming | 5/2013
595
M Effect TNC 640 iTNC 530
M134
M135
Exact stop at nontangential contour transitions when
positioning with rotary axes
Reset M134
– X
M136
M137
Feed rate F in millimeters per spindle revolution
Reset M136
X X
M138
Selection of tilted axes X X
M140 Retraction from the contour in the tool-axis direction X X
M141
Suppress touch probe monitoring X X
M142 Delete modal program information – X
M143
Delete basic rotation X X
M144
M145
Compensating the machine’s kinematic configuration for
ACTUAL/NOMINAL positions at end of block
Reset M144
X, option #09 X, option #09
M148
M149
Automatically retract tool from the contour at an NC stop
Reset M148
X X
M150 Suppress limit switch message – (possible via
FN 17)
X
M197 Rounding the corners X –
M200
-M204
Laser cutting functions – X
Comparison: Touch probe cycles in the Manual
Operation and El. Handwheel modes
Cycle TNC 640 iTNC 530
Touch-probe table for managing 3-D touch probes X –
Calibrating the effective length X X
Calibrating the effective radius X X
Measuring a basic rotation using a line X X
Set the datum in any axis X X
Setting a corner as datum X X
Setting a circle center as datum X X
Setting a center line as datum X X
Measuring a basic rotation using two holes/cylindrical studs X X
Setting the datum using four holes/cylindrical studs X X
Setting the circle center using three holes/cylindrical studs X X
Support of mechanical touch probes by manually capturing the current
position
By soft key By hard key
Writing measured values in preset table X X
Writing measured values in datum tables X X