HEIDENHAIN TNC 640 (34059x-02) ISO programming - Manual (Page 62)

First Steps with the TNC 640
1.6 Workpiece setup
1
62
TNC 640 | User's Manual for DIN/ISO Programming | 5/2013
1.6 Workpiece setup
Selecting the correct operating mode
Workpieces are set up in the Manual Operation or Electronic
Handwheel mode
Press the Manual Operation operating mode key:
the TNC switches to that mode
Further information on this topic
Manual Operation mode: See "Moving the machine axes",
page 441
Clamping the workpiece
Mount the workpiece with a fixture on the machine table. If you
have a 3-D touch probe on your machine, then you do not need to
clamp the workpiece parallel to the axes.
If you do not have a 3-D touch probe available, you have to align the
workpiece so that it is fixed with its edges parallel to the machine
axes.