HEIDENHAIN TNC 640 (34059x-02) ISO programming - Manual (Page 58)

First Steps with the TNC 640
1.4 Graphically testing the first part
1
58
TNC 640 | User's Manual for DIN/ISO Programming | 5/2013
Starting the test run
Press the RESET + START soft key: The TNC
simulates the active program up to a programmed
break or to the program end
While the simulation is running, you can use the
soft keys to change views
Press the STOP soft key: The TNC interrupts the
test run
Press the START soft key: The TNC resumes the
test run after a break
Further information on this topic
Running a test run: See "Test Run", page 519
Graphic functions: See "Graphics ", page 506
Adjusting the test speed: See "Speed of the Setting test runs",
page 507