Yaskawa SI-EP3 PROFINET Technical Manual - Manual (Page 13)

5 Installation Procedure
YASKAWA ELECTRIC SIEP C730600 69A 1000-Series Option SI-EP3 Technical Manual 13
 Prior to Installing the Option
Note: Refer to the instruction manual of a specific drive for details.
Prior to installing the option, wire the drive, make necessary connections to the drive terminals, and verify that the drive
functions normally without the option installed. Refer to the instruction manual packaged with the drive for information
on wiring and connecting the drive.
Figure 2 shows an exploded view of the drive with the option and related components for reference.
Figure 2
Figure 2 Drive Components with Option (CIMR-A2A)
Properly connect all pins and connectors.
Failure to comply may prevent proper operation and possibly damage equipment.
Check wiring to ensure that all connections are correct after installing the option and connecting any other
devices.
Failure to comply may result in damage to the option.
A – Insertion point for CN5 connector I – Ground wire
B – SI-EP3 option J – Option modular connector CN1 port 1
C – Drive front cover K – Option modular connector CN1 port 2
D – Digital operator L – Drive grounding terminal (FE)
E – LED label M – Connector CN5-A
F – Drive terminal cover N – Connector CN5-B
G – Removable tabs for wire routing O – Connector CN5-C
H – Included screws
NOTICE
F
H
M
N
O
L
K
I
B C
D
E
A
G
J
NS MS
A1000
PROFINET_E_conditional.book 13 ページ ２０１５年２月２５日 水曜日 午後５時１７分