Yaskawa PROFINET - Manual (Page 15)

5 Installation Procedure
YASKAWA SIEP YEACOM 07A 1000-Series Option PROFINET SI-EP3 Technical Manual 15
3.
Insert the option (E) into the CN5-A connector (C) located on the drive and fasten it using one of the included
screws (K).
Figure 5
Figure 5 Insert the Option
4.
Connect the ground wire (L) to the ground terminal (N) using one of the remaining provided screws (K). Connect
the other end of the ground wire (L) to the remaining ground terminal and installation hole on the option (E) using
the last remaining provided screw (K) and tighten both screws to 0.5 ~ 0.6 nm or (4.4 ~ 5.3 in lbs).
Figure 6
Figure 6 Connect the Ground Wire
Note: There are two screw holes on the drive for use as ground terminals. When connecting three options, two ground wires will need to
share the same drive ground terminal.
NS MS
C
D
K
E
NS MS
K
L
E
N