Typical main circuit wiring examples, Single-phase 100v/200v main circuit, Single-phase 100 v/200 v m ain circuit – Yaskawa FSP Short Form User Manual
Page 29
FSP Amplifier Short Form Installation Guide
Wiring
5.4. Typical Main Circuit Wiring Examples
Only qualified personnel should perform the wiring. Design the circuit so that the
main circuit power supply turns OFF at emergency stop.
5.4.1. Single-phase 100V/200V Main Circuit
FSP Amplifier
1Ry
:
Relay
1QF : Molded-case circuit breaker 1PL : Indicator lamp
FIL : Noise filter
1SUP : Surge suppressor
1KM : M agnetic contactor
1D : Flywheel diode
*1. T hese circuits are power lines. Do not touch these terminals when the
power is ON to avoid electric shock.
*2. T hese circuits are SELV circuits and are separated from all other
circuits by double and reinforced insulation. T he CN1 input signal is
available for sink or source circuits.
Note: Customers must purchase a 24VDC power supply with a double-
shielded enclosure.
29