Yaskawa V1000-Series Option SI-EP3/V PROFINET User Manual
Page 29
7 Procedure B
YASKAWA SIEP YEACOM 06A V1000 Option PROFINET SI-EP3/V Technical Manual
29
9.
Firmly connect RJ45 8-pin Shielded Twisted Pair Cat5e cable(s) into the modular connector ports to connect the
option to a network,
Refer to Network Topology and Connections on page 32
.
NOTICE: Do not connect or disconnect the communication cable while the drive is powered up or while the drive is in operation. Failure
to comply may cause a static discharge, which will cause the option card to stop working properly. Cycle power on the drive and option
card to attempt to reestablish functionality.
Figure 33
Figure 33 Communication Cable Ports
10.
Attach the option cover by aligning the tabs with the mounting slots.
Figure 34
Figure 34 Attach the Option Cover
Ground wire to
drive ground terminal
screw
RJ45 8-pin Shielded Twisted Pair
Cat5e cable(s)
Option cover
Mounting tab
Cover
mounting slot
Cover
mounting slot
Ground wire to
drive ground screw
Mounting tab
Cat5E cables