Epson ARM.POWERED ARM720T - Manual (Page 44)

2: Programmer’s Model
2-4 EPSON ARM720T CORE CPU MANUAL
2.5 Operating modes
The ARM720T processor supports seven modes of operation, as shown in Table 2-1.
2.5.1 Changing operating modes
Mode changes can be made under software control, by external interrupts or during exception
processing. Most application programs execute in User mode. The non-User modes, known as
privileged modes, are entered in order to service interrupts or exceptions, or to access
protected resources.
2.6 Registers
The ARM720T processor has a total of 37 registers:
• 31 general-purpose 32-bit registers
• six program status registers.
These registers cannot all be seen at once. The processor state and operating mode dictate
which registers are available to the programmer at any one time.
2.6.1 The ARM state register set
In ARM state, 16 general registers and one or two status registers are visible at any one time.
In privileged (non-User) modes, mode-specific banked registers are switched in. Figure 2-3 on
page 2-5 shows which registers are available in each mode. The banked registers are marked
with a shaded triangle.
The ARM state register set contains 16 directly accessible registers, r0 to r15. All of these,
except r15, are general-purpose, and can be used to hold either data or address values.
Registers r14 and r15 also have special roles, as follows:
Register r14 This register is used as the subroutine Link Register. This receives
a copy of r15 when a Branch and Link (BL) code instruction is
executed. At all other times it can be treated as a general-purpose
register. The corresponding banked registers r14_svc, r14_irq,
r14_fiq, r14_abt, and r14_und are similarly used to hold the return
values of r15 when interrupts and exceptions arise, or when BL
instructions are executed within interrupt or exception routines.
Register r15 This register holds the Program Counter (PC). In ARM state, bits
[1:0] of r15 are zero and bits [31:2] contain the PC. In Thumb state,
bit 0 is zero and bits [31:1] contain the PC.
In addition to these, the Current Program Status Register (CPSR) is used to store status
information. It contains condition code flags and the current mode bits.
Table 2-1 ARM720T modes of operation
Mode Type Description
User usr The normal ARM program execution mode
FIQ fiq Used for most performance-critical interrupts in a system
IRQ irq Used for general-purpose interrupt handling
Supervisor svc Protected mode for the operating system
Abort mode abt Entered after a Data Abort or instruction Prefetch Abort
System sys A privileged User mode for the operating system
Undefined und Entered when an Undefined Instruction is executed