Emerson Liebert Static Transfer Switch - Manual (Page 72)

Operating Instructions for the Touch Screen Interface
64
10.0 O
PERATING
I
NSTRUCTIONS FOR THE
T
OUCH
S
CREEN
I
NTERFACE
After the initial equipment startup, the following operating guidelines can be used for standard
equipment operation. These guidelines should be reviewed for any special equipment modifications,
special site conditions, or company policies that may require changes to the standard equipment oper-
ation.
All programmable functions are preset at the factory to enable the unit to be brought up without the
need to enter all selectable parameters.
This section refers to the LCD touch screen display. This display is discussed in more detail later in
the manual. See 13.0 - Liebert STS2 Touch Screen Display.
See Figures 14- 19 for circuit breaker locations.
!
CAUTION
Before the unit is placed into service for the first time, after equipment relocation, or after the
equipment has been de-energized for an extended period of time, a thorough equipment
inspection and supervised startup by qualified personnel are strongly recommended. Contact
your local Emerson Network Power representative or Liebert Services at 1-800-543-2378 to
arrange for equipment inspection and startup.
NOTE
If the front panel of your Liebert STS2 has LEDs and push buttons instead of the touch screen
interface, refer to 14.0 - Operating the Liebert STS2 LED Display for operating
instructions.