RISCO Group ACIS - Manual (Page 55)

User Manual for ACIS Version
Uncontrolled when printed © RISCO Group 46
Figure 33: Delete the Controller
2. Click Delete. The system displays a message, “Are you sure you want to delete this Controller?”
3. Click OK. The controller is deleted.
4.5
Add a Template Controller
A Template Controller is added when there is no physical device present, but is expected to be available. You
can replace the Template Controller by the Actual Controller when the device is available. The configuration and
the settings done on the Template Controller are applied to the replaced controller.
With the help of Template Controller, you can configure the controller before actually installing the hardware.
To add a Template Controller:
1. Click Add Template Controller. The Add Template Controller screen appears. There are four tabs on the
screen, General, Relay, Sensors, and Reader Details.
The General tab appears by default. You can enter the general details of the Template Controller in this tab.
4.5.1 General
To configure the general details of the controller: