Rosen Aviation 9000 Series : 9 inch High Definition SlimLine - Manual (Page 12)

Rosen Aviation Personal Displays
Document Number: 104461 Revision: F
Date: 03/13/14
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 12 of 32
4.4. Pinout Connections
There are several ways to connect a personal display to an aircraft’s entertainment system.
Use the pinout descriptions on the monitor’s Outline and Installation drawing to assist in
completing the wiring connections.
Note:
This display is for entertainment purposes only; connect to a non-critical power bus.
5. INITIAL POWER UP
Make sure to turn off the power before connecting the harnesses.
1. Ensure low impedance ground connections on the base.
2. Ensure that 28 VDC power supply is OFF
3. Connect the power supply and video source to the appropriate harnesses.
4. Supply power and wait for a video signal on the screen. The default setting for most
personal displays is Auto On and the default source should display on the screen.
For in-seat monitors, deploy the display by pressing down on the latch button, as
shown below. Stow and deploy the display to observe the latch mechanism, harness
movement, and the limit switch. The display should automatically turn on when
deployed and turn off when stowed.
Figure 14 In-seat display power controls
Do not plug or unplug the display connector while power is
applied.
When cycling power, leave unit off for 20 seconds before restoring
power.
Limit switch
lever and set
screw control
the power on
in-seat displays
Latch button