In-seat display adjustments – Rosen Aviation 9000 Series : 9 inch High Definition SlimLine User Manual
Page 13
Rosen Aviation
Personal Displays
Document Number: 104461
Revision: F
Date: 03/13/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 13 of 32
5.1. In-seat Display Adjustments
If an in-seat display does not shut off when it is stowed, adjust the set screw directly above the
limit switch lever so that the limit switch activates when monitor is stowed.
To prevent damage to the switch, be sure the limit switch lever
does not bottom out on the switch body.
Figure 15 Set screw and limit switch positions for power on/off control
If the power harness stretches or is kinking while stowing or deploying, loosen the cable clamp,
remove cable ties, and reposition the harness. For optimum reliability, the power harness should
have a minimum bend diameter of one-half inch, as shown below. Re-secure the cable ties and
tighten the cable clamp.
Figure 16 Harness position for optimal reliability
Adjust set screw
to contact limit
switch
Cable tie in base
Second cable tie on
limit switch wires
Proper
contact for
the limit
switch lever