Rosen Aviation 9000 Series : 9 inch High Definition SlimLine - Manual (Page 23)

Rosen Aviation Personal Displays
Document Number: 104461 Revision: F
Date: 03/13/14
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 23 of 32
8.1.4. AGC (Automatic Gain Control)
(Composite only) This option is a signal compensation tool that will accommodate for
strong and weak Composite signals.
Highlight AdvancedAGC and press Menu.
Use + and – to set the option and then press Menu.
Select Back to return to the Technician Menu.
Select Back and Exit to exit the OSD.
8.2. Power Mode
Use Power Mode to set the display’s startup state. Power Mode works the same on all
personal displays; however, on SDI -3xx models the option is in the
Technician MenuMode Menu.
From the Technician Menu, press – to select Power Mode and then press Menu.
Use + and – to set the desired power mode, and then press Menu.
Options include the following:
 Auto-On:
The display always starts up in the ON state when 28V is applied (default).
 Auto-Off:
The display always starts up in the standby state when 28V is applied.
 Restore Previous:
The display returns to the previous power settings after any power
interruption.
Select Back to return to the Technician Menu.
Select Back and Exit to exit the OSD.
8.3. Mode Menu
(For SDI -3xx models only) Use the Mode Menu options to specify the power mode and access
the SDI Overscan settings. From the Technician Main Menu, highlight Mode Menu, and then
press Menu.
Figure 31 Technician Mode Menu for -3xx models