Rosen Aviation 9000 Series : 9 inch High Definition SlimLine - Manual (Page 24)

Rosen Aviation Personal Displays
Document Number: 104461 Revision: F
Date: 03/13/14
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 24 of 32
8.3.1. Power Mode
Power Mode is in the Technician ModeMode Menu for SDI -3xx models and on the
Technician Menu for all other personal displays. For information about how Power Mode
works, see Section 8.2 , Power Mode , on page 23 .
8.3.2. Operation Mode
(For SDI -3xx models only) Operation Mode is a read-only option set to None Selected;
no operation modes are applicable.
8.3.3. SDI Overscan
(For SDI -3xx models only) Use SDI Overscan to enable or disable video overscan for
SDI at 480i and 576i resolutions. When enabled, the setting cuts off a small percentage
(2.5% by default) around the edges of the image and resizes it to fit the full screen. When
set to disabled, a zero percent overscan is applied to all SDI resolutions. You can also
enable/disable this feature via the RS-232 protocol.
From the Technician Menu, press – to select Mode MenuSDI Overscan and then
press Menu.
Use + and – to set the option to Enabled or Disabled, and then press Menu.
Select Back to return to the Technician Menu.
Select Back and Exit to exit the OSD.
8.3.4. SDI Overscan %
(For SDI -3xx models only) Use SDI Overscan % to set the amount of overscan applied
to the picture’s edges of SDI signals at 480i and 576i resolutions—you will not see
overscan with any other resolutions. The setting percentages are 0.0%, 2.5% (default),
3.0%, 5.0%, and 10.0%. The overscanned image will automatically update and the
screen will briefly go black when you switch between percentage values. You do not
have to cycle power for the change to take effect. You can also change the overscan
value via the RS-232 protocol.
From the Technician Menu, press – to select Mode MenuSDI Overscan % and then
press Menu.
Use + and – to set the percentage option and then press Menu.
Select Back to return to the Technician Menu.
Select Back and Exit to exit the OSD.