TA Triumph-Adler CLP 4721 - Manual (Page 101)

Using the Operation Panel
4-42
Color Mode (Selecting color or Black & White printing)
You can use the Color Mode menu on the operation panel to select the
Black & White or Color printing mode. By default, the printer is set to print
in color mode.
1
Press Z while Print Settings > is displayed.
2
Press U or V repeatedly until >Color Mode appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Press U or V to change color mode — Color or Black & White.
5
When the desired color mode is displayed, press [OK]. Color mode
is changed.
6
Press [MENU]. The display returns to Ready.
Print Quality (Setting print quality)
This selects the gloss mode (Low or High) and whether EcoPrint (low-
toner printing) is used for printing.
The options available in Print Quality are as follows:
• Gloss Mode (Selecting the gloss mode)
• EcoPrint Mode (Selecting the EcoPrint mode)
1
Press Z while Print Settings > is displayed.
2
Press U or V repeatedly until >Print Quality > appears.
Gloss Mode (Selecting the gloss mode)
Gloss mode, when set to High, increases the effect of glossiness in
printing by reducing the printing speed by half. Gloss mode is not
available when LABELS and TRANSPARENCY is selected as the paper
type setting.
IMPORTANT Depending on the paper used, printing in gloss mode
may cause wrinkle in paper. To reduce wrinkle, try using thicker pa-
per.
Use the procedure below to select Gloss mode. The default setting is
Low
.
1
Press Z while >Print Quality > is displayed.
2
Press U or V repeatedly until >>Gloss Mode appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select Low or High using U or V.
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
>Color Mode
? Color
>Print Quality >
>>Gloss Mode
? Low