Moisture content, Paper grain, Other paper properties – TA Triumph-Adler CLP 4721 User Manual

Page 47

Advertising
background image

Handling Paper

3-6

are having problems with paper jams and blurred printing the paper may

be too thick. The correct thickness is 0.086 to 0.110 mm (3.4 to 4.3 mils).

Moisture Content

Moisture content is defined as the percent ratio of moisture to the dry

mass of the paper. Moisture can affect the paper’s appearance, feed

ability, curl, electrostatic properties, and toner fusing characteristics.
The moisture content of the paper varies with the relative humidity in the

room. When the relative humidity is high and the paper absorbs moisture,

the paper edges expand, becoming wavy in appearance. When the

relative humidity is low and the paper loses moisture, the edges shrink

and tighten, and print contrast may suffer.
Wavy or tight edges can cause jams and alignment anomalies. The

moisture content of the paper should be 4 to 6 %.
To ensure correct moisture content, it is important to store the paper in a

controlled environment. Some tips on moisture control are:
• Store paper in a cool, dry location.
• Keep the paper in its wrapping as long as possible. Re-wrap paper

that is not in use.

• Store paper in its original carton. Place a pallet etc. under the carton

to separate it from the floor.

• After removing paper from storage, let it stand in the same room as

the machine for 48 hours before use.

• Avoid leaving paper where it is exposed to heat, sunlight, or damp.

Paper Grain

When paper is manufactured, it is cut into sheets with the grain running

parallel to the length (long grain) or parallel to the width (short grain).

Short grain paper can cause feeding problems in the machine. All paper

used in the machine should be long grain.

Other Paper Properties

Porosity: Indicates the density of paper fiber.
Stiffness: Limp paper may buckle in the machine, resulting in paper

jams.
Curl: Most paper naturally tends to curl one way if left unpacked.
Electrostatic discharge: During the printing process the paper is

electrostatically charged to attract the toner. The paper must be able to

release this charge so that printed sheets do not cling together in the

Output Tray.

Whiteness: The contrast of the printed page depends on the whiteness

of the paper. Whiter paper provides a sharper, brighter appearance.

Quality control: Uneven sheet size, corners that are not square, ragged

edges, welded (uncut) sheets, and crushed edges and corners can cause

the machine to malfunction in various ways. A quality paper supplier

should take considerable care to ensure that these problems do not

occur.

Note When using coated paper, be aware that the sheets will

stick together in a very humid environment.

Advertising
This manual is related to the following products: