Amprobe GP-2 Geo-Test - Manual (Page 28)

GP-2 GeoTest
EN - 28
8. MAINTENANCE
8.1. GENERAL
GP-2 GeoTest is a precision instrument. During its use and for its storage follow the
recommendations and instructions contained in this manual in order to avoid possible
damage or danger.
Never use the instrument in environments with a high humidity or temperature.
Do not expose the instrument to direct sunlight.
Always turn off the instrument after use. If you expect to not use it for extended periods,
remove the batteries.
8.2. BATTERY REPLACEMENT
When the symbol appears, the batteries must be replaced.
WARNING:
Only qualified technicians can perform this operation.
Before replacing the fuse/fuses disconnect the alligator clips
from circuit under voltage in order to avoid electrical shocks.
The tester is capable of keeping the values stored for
approx. 10 minutes.
1. Disconnect the cables from the input terminals.
2. Set the switch to the OFF position.
3. Remove the battery cover screws and then remove the cover.
4. Replace the batteries with 6 new ones of the same type: 1.5V– AA (– LR6– AM3 – MN
1500).
5. Reposition the cover and replace the screws.
8.3. CLEANING
Use a soft dry cloth to clean the instrument. Do not use wet clothes, solvents, water etc.