PLANET WGSW-2620HP - Manual (Page 18)

User’s Manual of WGSW-2620HP
„ Per 10/100Mbps port, PoE interfaces (Port-1 to Por-24)
LED Color Function
Lights : To indicate the link through that port is successfully established.
LNK/ACT Green
Blink: To indicate that the Switch is actively sending or receiving data over that port.
Lights : To indicate the port is providing 52V DC in-line power.
PoE In-Use Orange
Off: To indicate the connected device is not a PoE Powered Device (PD).
„ Per 10/100/1000Base-T port / SFP interfaces
LED Color Function
Lights: To indicate the link through that port is successfully established with speed
1000Mbps.
Blink : To indicate that the Switch is actively sending or receiving data over that port.
1000
LNK/ACT
Green
Off:
If 10/100 LNK/ACT LED is light, it indicates that the port is operating at 10Mbps or
100Mbps. If LNK/ACT LED is Off, it indicates that the port is link down.
Lights: To indicate the link through that port is successfully established with speed
10Mbps or 100Mbps.
Blink : To indicate that the Switch is actively sending or receiving data over that port.
10/100
LNK/ACT
Green
Off:
If 1000 LNK/ACT LED is light, it indicates that the port is operating at 1000Mbps.
If 1000 LNK/ACT LED is Off, it indicates that the port is link down.
1. Press the RESET button 5 seconds . The Managed Switch will reboot automatically.
2. Press the RESET button for about 10 seconds . The Managed Switch will back to the factory default
mode; the entire configuration will be erased.
3. The 2 Gigabit TP/SFP combo ports are shared with port 25/26 of Managed Switch. Either of them can
operate at the same time.
18