PLANET BSP-300 - Manual (Page 22)

User’s Manual of BSP-300
21
Step 5. Connect other device
(1) Connect any other network device to Port 3 of BSP-300.
If there is device require DC power, connect the pin 3 / pin 4 of the terminal block from
BSP-300 directly.
NOTE:
1. The maximum DC out from BSP-300 is 24VDC, 2A.
2. The external device should also be grounded properly.
After the 5 steps above, the BSP-300 is ready for service.
3.2 Software Overview
About the Solar Controller Utility:
The “Solar Controller Utility” is a software tool provided for the user to configure the controller
parameters so as to achieve the best application condition. Before the configuration operation,
please contact the suppliers of your PV panel, PoE device, and battery for the product­specific
parameters.
(2)