PLANET WNAP-3000PE - Manual (Page 7)

Status On - Error condition.
Off - Normal operation.
Blinking - During start up, and when the Firmware is being upgraded.
LAN On - The LAN port is active.
Off - No active connection on the LAN port.
Flashing - Data is being transmitted or received via the corresponding
LAN port.
Back Panel
Reset Button This button has two (2) functions:
• Reboot - When pressed and released, the Wireless Ac-
cess Point will reboot (restart).
• Reset to Factory Defaults - This button can also be used
to clear ALL data and restore ALL settings to the factory
default values.
To Clear All Data and restore the factory default values:
1. Hold the Reset Button until the Status (Red) LED blinks
TWICE, usually more than 5 seconds.
2. Release the Reset Button.
The factory default configuration has now been restored,
and the Access Point is ready for use.
LAN Use a standard LAN cable (RJ45 connectors) to connect this
port to a 10/100/1000BaseT hub/switch on your LAN.
Power Connect the supplied power adapter (12V@1A) here.
2