PLANET WNAP-1120 - Manual (Page 10)

Chapter 2 Hardware Installation
Before you proceed with the installation, it is necessary that you have enough information about the
WNAP-1120.
1. Locate an optimum location for the WNAP-1120. The best place for your WNAP-1120 is
usually at the center of your wireless network, with line of sight to all of your mobile stations.
2. Assemble the antenna to WNAP-1120. Try to place them to a position that can best cover your
wireless network. The antenna’s position will enhance the receiving sensitivity.
3. Connect RJ-45 cable to WNAP-1120. Connect this WNAP-1120 to your LAN switch/hub or a
single PC.
4. Plug in power adapter and connect to power source. After power on, WNAP-1120 will start to
work.
Note: ONLY use the power adapter supplied with the WNAP-1120. Otherwise, the product may be
damaged. If you want to reset your WNAP-1120 to default settings, press the Reset button
15 seconds. Then release the button and wait for 10 seconds for rebooting.
10