PLANET WNAP-7205 - Manual (Page 48)

User’s Manual of WNAP-7205
Data Beacon Rate(DTM) This is the Delivery Traffic Indication Map. It is used to alert the clients
that multicast and broadcast packets buffered at the AP will be
transmitted immediately after the transmission of this beacon frame.
You can change the value from 1 to 255. The AP will check the buffered
data according to this value. For example, selecting “1” means to check
the buffered data at every beacon.
Fragment Threshold The fragmentation threshold determines the size at which packets are
fragmented (sent as several pieces instead of as one block). Use a low
setting in areas where communication is poor or where there is a great
deal of radio interference. This function will help you to improve the
network performance.
RTS Threshold The RTS threshold determines the packet size at which the radio issues
a request to send (RTS) before sending the packet. A low RTS
Threshold setting can be useful in areas where many client devices are
associating with the device, or in areas where the clients are far apart
and can detect only the device and not each other. You can enter a
setting ranging from 0 to 2347 bytes.
TX Power The default TX power is 100%. In case of shortening the distance and
the coverage of the wireless network, input a smaller value to reduce
the radio transmission power. For example, input 80 to apply 80% Tx
power.
Short Preamble Default: Disable. It is a performance parameter for 802.11 b/g mode
and not supported by some of very early stage of 802.11b station cards.
If there is no such kind of stations associated to this AP, you can enable
this function.
Short Slot
It is used to shorten the communication time between this AP and
station.
TX Burst
The device will try to send a serial of packages with single ACK reply
from the clients. Enable this function to apply it.
Country Code Select the country code for wireless from pull down menu.
Carrier Detect Select Enabled to enable Carrier Detect.
- 48 -