PLANET ICA-H612 - Manual (Page 60)

- 60 -
Cruise Setting
To setup a Cruise Path, please first select a path number from the drop-down list. Then move the cursor
to the live view pane, and move the camera to a desired view (PTZ controls) as the start point of a
Cruise Path. Press the “Set” button of “Record Start” and start programming the Cruise Path via PTZ
controls. When finishing programming, press the “Set” button of “Record End” to quit. Then this Cruise
Path will be automatically recorded.
Cruise Run
Select the specified Cruise Path from the drop-down list, press the “Run” button, and then the camera
will start touring around as recorded.
To view the camera touring around in full screen mode, please move the cursor onto the live view pane,
right-click and left-click to select “fullscreen”. Then users can view the camera navigation in full screen.
To stop running a Cruise Path, simply move the cursor to the live view pane and move the camera in
any direction.
4.5.3 Auto Pan
The Speed Dome IP Camera supports four Auto Pan Paths. Please refer to the instructions below to
set an Auto Pan Path.