ProSoft Technology MVI69-EGD - Manual (Page 45)

Diagnostics and Troubleshooting MVI69-EGD ♦ CompactLogix or MicroLogix Platform
GE Ethernet Global Data Communication Module
ProSoft Technology, Inc. Page 45 of 96
November 3, 2008
4 Diagnostics and Troubleshooting
In This Chapter
™ Reading Status Data from the Module .................................................. 45
™ LED Status Indicators............................................................................ 57
The module provides information on diagnostics and troubleshooting in the
following forms:
ƒ Status data values are transferred from the module to the processor.
ƒ Data contained in the module can be viewed through the
Configuration/Debug port attached to a terminal emulator.
ƒ LED status indicators on the front of the module provide information on the
module's status.
4.1 Reading Status Data from the Module
The MVI69-EGD module returns a 20-word Status Data block that can be used to
determine the module's operating status. This data can be located in the
module's database at registers at the location specified in the configuration. This
data is transferred to the CompactLogix or MicroLogix processor continuously
with each read block.
4.1.1 Required Hardware
You can connect directly from your computer's serial port to the serial port on the
module to view configuration information, perform maintenance, and send
(upload) or receive (download) configuration files.
ProSoft Technology recommends the following minimum hardware to connect
your computer to the module:
ƒ 80486 based processor (Pentium preferred)
ƒ 1 megabyte of memory
ƒ At least one UART hardware-based serial communications port available.
USB-based virtual UART systems (USB to serial port adapters) often do not
function reliably, especially during binary file transfers, such as when
uploading/downloading configuration files or module firmware upgrades.
ƒ A null modem serial cable.