ProSoft Technology PTQ-PDPMV1 - Manual (Page 142)

Configuring the Processor with Concept 2.6 PTQ-PDPMV1 ♦ Quantum Platform
User Manual PROFIBUS DP Master Network Interface Module for Quantum
Page 142 of 306 ProSoft Technology, Inc.
August 12, 2014
4.12.8 SetOperatingMode Mailbox
Function Block: SETOPMD
Trigger Register: SetOper, SetStop, SetClear
Description: The following trigger values can be used to change the current
operating mode of the module:
SetOper = Set Operate
SetStop = Set Stop
SetClear = Set Clear
4.12.9 SetSlaveMode Mailbox
Function Block: SETSLVMD
Trigger Register: SetMdSlv
Description: The SETSLVMD function block can be used to request the module
to sync, unsync, freeze, or unfreeze. The slave address must be selected
through the SlvAddIn input pin. If the operation is directed to a group of slaves
then the group number must be set through the GroupIn input pin parameter. The
actual code that will select the operation type must be configured through the
CntrlIn input pin. Refer to the User Manual for the valid control codes.