ProSoft Technology PTQ-PDPMV1 - Manual (Page 17)

PTQ-PDPMV1 ♦ Quantum Platform Start Here
PROFIBUS DP Master Network Interface Module for Quantum User Manual
ProSoft Technology, Inc. Page 17 of 306
August 12, 2014
1.4 Installing the Module
1.4.1 Installing the ProTalk Module in the Quantum Rack
1 Place the module in the Quantum rack. The ProTalk module must be placed
in the same rack as the processor.
2 Tilt the module at a 45

angle and align the pegs at the top of the module with
the slots on the backplane.
3 Push the module into place until it seats firmly in the backplane.
CAUTION: The PTQ module is hot-swappable, meaning that you can install and remove it while
the rack is powered up. You should not assume that this is the case for all types of modules unless
the user manual for the product explicitly states that the module is hot-swappable. Failure to
observe this precaution could result in damage to the module and any equipment connected to it.
HSBY Note: For HSBY setup, repeat the above procedures for the Primary and Standby
modules.