ProSoft Technology AN-X-AMX - Manual (Page 14)

Page 10 AN-X-DCSNet2 November 2011
The preferred method is to cycle power on the AN-X. Select the first
option on the screen, power off the AN-X, and click the Next >> button.
The second method, useful if the AN-X in not easily accessible, is to
send it a command over Ethernet. The AN-X must be powered on and
completely running for this method to work. For example, if this is the
first time you are configuring a new AN-X, allow sufficient time for it to
acquire an IP address from a DHCP server or to time out and use its
default IP address (about 3 minutes). Select the second option on the
screen and click the Next >> button.
Step 3:
If you powered off the AN-X, turn it back on. Wait for AN-X to enter
boot mode. While AnxInit is waiting, the Next>> button is disabled.
When AN-X is in boot mode, the Next>> button is enabled.