ProSoft Technology AN-X-AMX - Manual (Page 9)

AN-X-DCSNet2 Page 5
Installation
Prevent Electrostatic Discharge
The module is sensitive to electrostatic discharge.
WARNING!
Electrostatic discharge can damage integrated circuits or
semiconductors. Follow these guidelines when you handle the module:
• Touch a grounded object to discharge static potential
• Do not touch the connector pins
Power
AN-X requires a DC power input of anywhere from 12 to 24 VDC.
Left to right the pins on the power connector are chassis ground, negative
voltage and positive voltage.
The chassis ground should be connected.
Power consumption internally is 300 mA @ 12VDC or 150 mA @
24VDC.
The part number for the power connector is Phoenix MSTB
2.5/3-ST-5.08
Contact us if you need a suitable wall adapter.
DCSNet Cabling and Termination
Use a DCSNet drop cable (612574-36R or 612403-036R) and passive tap
(M/N 57C380) to connect the module to the coaxial network cable.
The drop cable is a 3-foot long multiconductor cable with 9-pin D-shell
connectors at each end. Connect one end to the connector on the module
and the other end to the passive tap.