ProSoft Technology AN-X-AMX - Manual (Page 16)

Page 12 AN-X-DCSNet2 November 2011
Enter a Host Name for the AN-X. This name is used internally by AN-X
and may be used to identify the AN-X if you have a DNS server on your
network. The name can be from 1 to 31 characters long.
To configure the AN-X to obtain its IP address from a DHCP server on
the network, select Obtain an IP address automatically (DHCP)
To configure the AN-X to use a static IP address, select Use the
following Settings
and enter:
• the desired IP address for the AN-X.
• the Subnet mask for the AN-X
• the default gateway for your network.
You must enter a valid default gateway address even if there is no device
at the gateway address on the network.
Click OK to complete the configuration.
If you Cancel the Configuration/AN-X IP Settings command, AN-X is
left running the boot code. Use the Utilities/Restart AN-X command to
restart the AN-X.
You can also reconfigure the AN-X IP parameters from the web
interface. Refer to page 55.
Example: Standalone Computer
A typical example is a laptop computer running the AutoMax
programming software and connecting directly to an AN-X to program
an AutoMax processor.
Since you are connecting directly from the computer to AN-X, use a
crossover Ethernet cable.
The following instructions assume that an Ethernet network card has
been installed in the computer and that AnxInit has been installed on the
computer.
TIP
The parameters in this example will work when you set up any
standalone computer to work with AN-X.
First configure the computer to use a static IP address. From the Start
menu, select Start/Settings/Network and Dialup Connections. Double
click on Local Area Connection.