Arturia KeyStep - Controller / Sequencer - Manual (Page 65)

If you double-click in the next step a new note will appear. The overlapped arrow shows that
the two notes are tied:
You can click on the second note and drag the cursor to the right again until the second
note’s length value also becomes TIE, and so on.

When the lengths of multiple notes are edited at the same time they will all change to the same
value.

A value of Tie does different things for the CV/Gate output and over MIDI:
• CV/Gate output: the note that follows a TIE will change the control voltage but
will not send a new gate signal to the attached device.
• MIDI output: the Note Off command for the first note happens after the Note On
command for the second note. This allows for “legato” playing on a monophonic
synthesizer.
8.9. Sequence management
8.9.1. Copy a Seq tab to another Seq tab
If you would like to make several sequences based on a common musical phrase, you can
take one sequence and copy it to one or more of the other tabs in the Seq window.

If the MCC and KeyStep have been synced this process will overwrite the target sequences in the
KeyStep internal memory.
To copy a sequence from one tab to the next, simply click the tab you want to copy and
drag on top of the destination tab.
Click and drag to copy Seq 1 to the Seq 5 location.
Arturia - User Manual KeyStep - MIDI Control Center 60