Arturia KeyStep - Controller / Sequencer - Manual (Page 71)

8.10.3. Sequence settings
Here’s a quick reference chart for those parameters:
Parameter Range/Values Description/Function
Sync Clock In/
Out settings 1step (Gate/Clock),
1pulse, 24ppq, 48 ppq
Set Sync input/output type. Refer to external device
documentation to determine what the settings should be.
Sync Clock
Start
On Clock, On Gate
Start
Determines which sort of signal will start KeyStep.
Next Seq
End, Instant Reset,
Instant Continue
Selects when the KeyStep sequences will change and whether
they’ll start from the top or the middle.
Transposition
Input port
USB, MIDI, both
Sequences can be transposed by external devices. This decides
which ones are allowed to do so.
Transpose
Input channel
1-16, all Specifies the MIDI channel to obey for transposition.
Transposition
Latch
On, off
Decides whether a sequence will only be transposed while a key
is held down.
Transpose
Center Pitch
Full MIDI note range Notes above/below center transpose the sequence up/down
Velocity As recorded, fixed Disregard velocity or not
Fixed Velocity
value
0-127 Set the preferred value
Tempo knob
mode
Jump, pickup Tempo can jump to knob position or wait for passthru
Tap Tempo
average
2, 3, or 4 taps Number of taps to respond
Arm to Start On, Off
Determines the start/stop behavior of the sequencer when
working with external clock sources
Arturia - User Manual KeyStep - MIDI Control Center 66