Canon Mk1500 Cable and Wire Marker Printer - Manual (Page 39)

35
Basic Operations Part 2
3
Install the ribbon cassette into the printer.
Push the cassette in until it clicks into place.
If the ribbon cassette is loose, the ribbon may not be detected, so be sure to press it in until
it clicks.
•
CAUTION Do not touch the connector (metal part)
Do not hold the connection terminal (metal part) of the cassette. Doing so could cause an
improper recognition of the cassette.
4
Install the label tape cassette into the printer.
Align the tab on the label tape cassette with
the hole in the printer, and then push the
cassette in until it clicks into place.
Con fi rm that the release paper is not peeled when setting the
label cassette. Before setting, cut the part where the release
paper is peeled or the end is not straight.
•
5
Remove the wrap-around tape guide.
page 18. •
6
Close the cover.
Close the cover completely so that it clicks shut.
Various cassettes
These cassettes must be purchased separately. Contact your nearest dealer for details.
Label tape cassette
This is used to print characters on label tape.
Heat shrink tube cassette
This is used to print characters on heat shrink tube.
Wrap-around tape cassette
This is used to print on wrap-around tape.
4mm I.D. strip cassette
This is used to print characters on 4mm I.D. strip.