When a tube or label tape is not ejected/fed, When a tube or label tape is not, Ejected/fed – Canon Mk1500 Cable and Wire Marker Printer User Manual

Page 98

Advertising
background image

94

When a Tube or Label Tape is Not Ejected/Fed

Using the Feed function in the maintenance mode allows you to feed the tube or label tape loaded in the printer.

Note that this function should be used only when the tube or label tape is not ejected or fed properly. Feeding
the tube or label tape continuously can damage the printing media or winds the ribbon of the ribbon cassette
around other parts, causing a jam.

For example, use the Feed function in the following cases:

Printing media is not released from the feed roller even when you press the [Remove] key to replace the printing media.
The printer is operating but printing media is not ejected after completion of printing.

In this case, the tube or label tape may be jammed inside the printer. Open the cover and check whether the tube or label tape is jammed. If it is
jammed, follow the jam removal procedure. Refer to “Actions to Take against Other Jams (When the “Media JAM” message is not displayed)”
(

page 92).

1

When the printer is operating (printing), keep pressing the [Cancel] key until a “peep” sound is

heard.

If the printer is not powered, turn it on.

2

Press the [Option] key.

A function selection display appears.

3

Select “3: Maintenance” by pressing the [

] or [

] key, and

then press the [Enter] key.

A function selection display appears.

4

Select “3: Feed” by pressing the [

] or [

] key, and then press

the [Enter] key.

A display indicating how to feed the printing media forward or
reverse appears.

5

Keep pressing the [

] or [

] key to feed the printing media to

the desired position.

Advertising