Canon Mk1500 Cable and Wire Marker Printer User Manual

Page 52

Advertising
background image

48

Attaching the wrap-around tape

1.

Peel the printed film from the wrap-around tape backing.

When wrapping, the laminating cover should overlap the printed part suf

fi

ciently. We

therefore recommend using with cable of

φ

3 to

φ

7.6 mm.

2.

Attach the tape to the cable as shown in the diagram,

starting from the printed end.

3.

Wrap the transparent laminating portion so that it covers

the printed part.

If the film does not peel away from the backing

Because wrap-around tape has a strong adhesive, it may be hard to peel the

fi

lm off the

backing. Refer to the following diagram for the peeling method.

Peel-off Film

Printable Area

Hold the backing

Peel the printed part away

If the cut is too shallow

Wrap-around tape is thicker than typical label tape, so the half-cut may be shallower.
In this case, refer to “What To Do If the Cutter Is Getting Blunt” on page 96 to adjust cutting
depth. If it still does not cut, replace with new cutter. ( page 98)

If the half-cut is too shallow, the

fi

lm may not peel from the backing properly.

If the remaining part cannot be separated, adjust the
cutting depth.

Printable Area

If this part is joined, pull apart with your
fingers

CANON FINETECH NISCA INC. shall not be responsible for damages
that might result from the tape peeling off, or from fading of the
printing on the tape.

Advertising