Canon Mk1500 Cable and Wire Marker Printer - Manual (Page 51)

47
Basic Operations Part 2
Print
Once the characters have been input, begin printing.
1
Press [Print/Print option].
The print media selection display appears.
“No ribbon cassette” is displayed if the ribbon cassette is not installed. Install the ribbon
cassette.
“No ribbon information. No ribbon amount displayed. Press enter” is displayed if the
information cannot be read due to the ribbon cassette failure and so forth. If this message
is displayed, follow the instruction on the screen.
What is “Print media”?
Print media is the material that you are printing on, such as a tube, heat shrink tube, label
tape, wrap around tape, 4mm I.D. strip, or clear tube.
•
2
Press [ ◄ ] or [ ► ] to select “6: Wrap-around”, and press [Enter].
The print quantity selection display appears.
Rough amount of the remaining ink ribbon is displayed as shown. When the information
of the cassette is not properly retrieved, the amount of the ribbon does not appear.
•
3
Press [3] and then [Enter].
Three pieces are printed. •
4
Confirm the position of the leading end of the wrap-around
tape, press [ ◄ ] or [ ► ] to select the input side, and press [Enter].
If the leading end of the loaded tape is at the transport roller 2, select [IN], and if its at the
cutter side, select [OUT].
Canceling printing
If you press [Cancel], the message “Aborting print” appears and
printing is aborted. In this case, the tape that is currently being
printed is cut and then ejected.
5
Take out the wrap-around tape.
A half-cut tape is ejected.
If tape jams
Hold down [Cancel] until the printer beeps. The
printer stops all operations immediately. In this
case, the tape is not cut and it is not ejected. Refer
to “If a Tube or Label Tape Becomes Jammed” (
page 90) and take out the jammed tape.
•
The tape is half-cut so
that it can be easily
separated by hand.